1.1 This specification covers chopped carbon-fiber reinforced (CFR) polyetheretherketone (PEEK) polymer in pellets, filaments used in additive manufacturing, or fabricated forms. It provides requirements and associated test methods for these thermoplastic composites when they are to be used in the manufacture of intracorporeal devices such as surgical implants or components of surgical or dental devices.1.2 The properties included in this specification are those applicable for chopped CFR-PEEK compounds and fabricated forms only. Materials or forms containing colorants, fillers other than carbon fibers, processing aids, or other additives, as well as polymer blends which contain PEEK, or reclaimed materials, are not covered by this specification.1.2.1 This standard does not include continuous carbon-fiber reinforced PEEK composites, which are fabricated using a different process than chopped CFR-PEEK.1.2.2 This standard can include CFR-PEEK compounds that are fabricated with the use of coupling (sizing) agents. However, when coupling agents are used to improve wetting of the carbon fibers, the biological risk assessments and biocompatibility testing should consider these coupling agents.1.3 This specification is designed to recommend physical, chemical, and biological test methods to establish a reasonable level of confidence concerning the performance of CFR-PEEK polymers for use in medical implant devices.1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.5 When evaluating material in accordance with this specification, hazardous materials, operations, and equipment may be involved.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车

This specification covers polyolefin chopped strands (fibers) for use in concrete. Tensile and tenacity properties are calculated by determining the breaking force, the breaking tenacity, and the elongation of adequately conditioned polyolefin filaments using Practice D1776. Conformance requirements for chopped strands for use in concrete include compliance with Specification C1116/C1116M, Type III as well as denier, finish content, tensile strength, and cut length.1.1 This specification covers polyolefin chopped strands (fibers) for use in concrete.1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.3 The following safety hazards caveat pertains only to the test methods described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车