【国外标准】 Standard Specification for Electrolytic Manganese Metal

This specification covers electrolytic manganese classified into Grades A (regular), B (intermediate hydrogen), C (low hydrogen), D (4.5% nitrogen bearing), E (6%nitrogen bearing) and F (weld graded powder). The specimens shall conform to the required chemical compositions of manganese, sulfur, hydrogen, nitrogen, iron, carbon, phosphorus, silicon, and aluminum.1.1 This specification covers several grades of electrolytic manganese designated as follows:  GradeRegular AIntermediate Hydrogen BLow Hydrogen C4.5 % Nitrogen Bearing D6 % Nitrogen Bearing EWeld Grade Powder F1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.1.2.1 This specification is expressed in both inch-pound units and in SI units (within the text, the SI units are shown in brackets); however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply.1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.