1. Scope 1.1 This Standard applies to stationary, permanently-connected hot-water and steam boilers for use on nominal system voltages of 600 V and less, for residential, commercial, and industrial use in nonhazardous locations in accordance with the

定价： 637元 / 折扣价： 542 元

定价： 6825元 / 折扣价： 5802 元

定价： 5551元 / 折扣价： 4719 元

Scope Details test and examination criteria for Category I, Category II, Category III and Category IV low-pressure steam and hot water boilers for use with natural, manufactured and mixed gases, liquefied petroleum gases and LP gas-air mixtures. A boil

定价： 774元 / 折扣价： 658 元

定价： 592元 / 折扣价： 504 元

定价： 0元 / 折扣价： 0 元

This specification covers hot- and cold-finished bars of stainless steel, including rounds, squares, and hexagons, and hot-rolled or extruded shapes such as angles, tees, and channels for use in boiler and pressure vessel construction. Four grades of the stainless steel are available which includes austenitic, austenitic-ferritic, ferritic, and martensitic grades. Mechanical properties such as tensile strength, yield strength, elongation, and hardness shall be determined for the specimens subjected to normalized, tempered, annealed, and quenched conditions. The austenitic stainless steels shall be subjected to heat treatment and shall undergo corrosion test.1.1 This specification2 covers hot- and cold-finished bars of stainless steel, including rounds, squares, and hexagons, and hot-rolled or extruded shapes such as angles, tees, and channels for use in boiler and pressure vessel construction.2NOTE 1: There are standards covering high nickel, chromium, austenitic corrosion, and heat-resisting alloy materials. These standards are under the jurisdiction of ASTM Subcommittee B02.07 and may be found in Annual Book of ASTM Standards, Vol 02.04.1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.3 Unless the order specifies the applicable “M” specification designation, the material shall be furnished to the inch-pound units.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 590元 / 折扣价： 502 元 加购物车

1. Scope This clause of Part 1 is applicable except as follows: 1.1 Replacement This standard applies to electrically operated commercial water boilers and liquid heaters for the boiling or heating of liquids to be used in the preparation of bev

定价： 637元 / 折扣价： 542 元

This PDF includes Amendments #1-14. 1. Scope 1.1 These requirements apply to natural and propane gas-fired packaged boilers. 1.2 The requirements in Part (A) of this Standard apply to package boilers, fire and water tube, steam and hot water, h

定价： 1138元 / 折扣价： 968 元