This part of IEC 60255 is for synchronized phasor measurement systems in power systems. It defines a synchronized phasor (synchrophasor), frequency, and rate of change of frequency measurements. It describes time tag and synchronization requirements for measurement of all three of these quantities. It specifies methods for evaluating these measurements and requirements for compliance with the standard under both static and dynamic conditions. It defines a phasor measurement unit (PMU), which can be a stand-alone physical unit or a functional unit within another physical unit. This document does not specify hardware, software or a method for computing phasors, frequency, or rate of change of frequency.
The scope of this standard is to define the Media Access Control (MAC) Service provided by all IEEE 802(R) MACs, and the Internal Sublayer Service (ISS) provided within MAC Bridges, in abstract terms of the following: a) Their semantics, primitive actions, and events; and b) The parameters of, interrelationship between, and valid sequences of these actions and events.
This standard defines an extensible IEEE 802® media access independent services framework (i.e., function and protocol) that enables the optimization of services including handover service when performed between heterogeneous IEEE 802 networks. It also facilitates these services when networking between IEEE 802 networks and cellular networks.
This part of IEC 62271 applies to all overhead, pad-mounted, dry vault and submersible single or multi-pole alternating current automatic circuit reclosers for rated maximum voltages above 1 000 V and up to and including 38 kV. Devices that require a dependent manual operation are not covered by this document. In order to simplify this document where possible, the term recloser (or reclosers) has been substituted for automatic circuit recloser(s) or cutout mounted recloser(s) or both.
a. Clause 4.10.4 the ratio of zero and positive sequence currents in single phase capacitive switching procedure should be less than 3.0 rather than greater than 3.0. b. Errors in clause 4.10.9.1.8 and 4.10.9.2.7 regarding reference to the procedure for separate making tests. c. 4.10.9.1.3 change in punctuation for clarity d. Throughout document unify terms for rated voltage, including in equations to use "Ur" rather than "V" f. Clause 4.1.2 i) is missing some words required for clear meaning.… read more g. Correct references and terms used by both C37.04 and C37.09 so they are identical h. Remove classification of tests in the Scope as only design tests are covered. i. Clauses 4.5.7 and 4.5.8.1 to make clear that average of the test impulses shall be equal or higher than rated value j. clarify in 4.8.2.7. which tests to be performed at minimum control voltage k. Correct item list in 4.8.2.3.3 l. Correct title of Figure 3 and correct Figure 4 (example for incorrect grounding condition given) m. Correct arcing window/multiplier in Table 5 n. Correct item list in 4.8.5.4.3 o. correct the steps of electrical degrees for capacitance switching duties in 4.10.9.2.7 (30° for single- and 10° for three phase) p. further minor items depending upon agreement in the WG read less
This standard defines the physical layer (PHY) and medium access control (MAC) sublayer specifications for low-data-rate wireless connectivity with fixed, portable, and moving devices with no battery or very limited battery consumption requirements. In addition, the standard provides modes that allow for precision ranging. PHYs are defined for devices operating various license-free bands in a variety of geographic regions.
This standard defines several media independent services (MIS); handover, home energy management system (HEMS), software-defined radio access networks (SDRANs), radio resource management (RRM), and device-to-device (D2D) communication that shall be implemented in conjunction with the MIS framework as defined in IEEE Std 802.21™-2017 to optimize the performance of such services.