本文件规定了在家庭和类似场合作普通照明用的、把稳定燃点部件集成为一体的LED灯。本文件规定了灯的安全和互换性要求,以及试验方法和检验其是否合格的条件。
适用范围如下:
——额定功率60 W及以下;
——额定电压不大于交流有效值50 V或无纹波直流120 V;
——灯头符合表1的要求。
注1:额定功率60 W正在研究中。热管理可能要求更低的功率。
本文件适用于特低电压(ELV)照明装置相连接的产品。
依据IEC 60364-7-715,在ELV照明装置中仅安全特低电压(SELV)源适用。如果使用裸导线,最大灯电压为交流25 V或直流60 V。
本文件的要求仅涉及型式试验。
大于交流25 V或直流60 V的灯的全部产品检验或批量检验建议参照GB/T 7000.1—2023的表Q.1,Ⅲ类灯具列,第4列或第5列。
注2:在本文件中使用术语“灯”代表符合上述范围中规定的电源电压的半集成式LED灯,除非另有说明为其他类型的灯。
IEC 62504中给出了LED模块、灯和控制装置组成的系统概述。电源电压不限定是电网电压(例如220 V/50 Hz)。电源电压为交流或直流12 V时,半集成式LED灯也能启动。灯控制装置的控制单元将交流或直流12 V 转换为特定的电流和电压供给灯中的LED。图1给出了非集成式LED灯和半集成式LED灯两种类型的示意图。
定价: 31元 / 折扣价: 27 元 加购物车
This standard specifies the terms and definitions, product classification and model, technical requirements, test methods and inspection rules of double-capped LED lamps with G5 and G13 lamp caps, which are used to replace the same lamp caps and conform to the provisions of GB/T 10682.
This standard is applicable to double-capped LED lamps with rated power of 125 W and below, frequency of 50 Hz, rated voltage of AC 220 V, nominal length of 1 500 mm and below and beam angle of 120° and above (for replacing liner fluorescent lamps).
This kind of double-capped LED lamps is used to replace the double-capped fluorescent lamp without any modification to the luminaire.
The existing luminaire to be installed with replaced double-capped LED lamps could be the with magnetic or electronic controlgear.
NOTE 1 Unless otherwise specified, "lamp" in this standard represents "double-capped LED lamps (for replacing liner fluorescent lamps)".
NOTE 2 The
定价: 588元 / 折扣价: 500 元 加购物车
This standard specifies the terms and definitions, specification classification and nomenclature, technical requirements, test methods and test rules of double-capped integrated LED lamps with G5 or G13 caps and for luminaries with G5 or G13 lamp bases but without ballasts.
This standard is applicable to double-capped integrated LED lamps, having:
—a rated power up to 60 W;
—a frequency of 50 Hz and a rated voltage of AC 220 V;
—a nominal length up to 1 500 mm;
—a beam angle of 120° and above.
This standard is also applicable to modified double-capped integrated LED lamps where modification in the luminarie is required and the ballasts are disconnected.
NOTE 1 Where in this standard the term "lamp(s)" is used, it is unterstood to stand for "double-capped integrated LED lamp(s)", except where it is obviously assigned to other types of lamps.
NOTE 2 The rated voltage is the power supplied to the luminaries.
定价: 516元 / 折扣价: 439 元 加购物车
This standard specifies the terms and definitions, classification and nomenclature, technical requirements, test methods and inspection rules of nondirectional integrated LED filament lamps for general lighting.
This standard is applicable to the nondirectional integrated LED filament lamp with integral means for stable operation components, intended for domestic and similar general lighting purposes.
定价: 588元 / 折扣价: 500 元 加购物车
我的标准
购物车
400-168-0010






对不起,暂未有相关搜索结果!










