定价： 元 加购物车

定价： 元 加购物车

定价： 540元 / 折扣价： 459 元

定价： 394元

定价： 1371元

定价： 1106元

定价： 530元

定价： 598元

定价： 862元

定价： 1211元

定价： 280元 / 折扣价： 238 元

定价： 0元 / 折扣价： 0 元

1.1 This test method describes a procedure for establishing the sizing accuracy of an automatic, optical liquid-borne single particle counter, using light scattering automatic particle counter (APC). This test method is directed at determining the sizing accuracy of the APC when it is used to measure a challenge suspension of precisely-sized spherical isotropic particles, particularly those sized at and below 1 [mu]m in diameter.1.2 The particle size parameter that is reported is the equivalent diameter based on the projected area of an isotropic spherical particle of known composition suspended in a liquid that is optically different from the suspended particle. Particles in the size range of 0.1 [mu]m and 5 [mu]m are used for calibration in this procedure.1.3 This test method does not provide a procedure for APC counting accuracy calibration, since that procedure is available in Practice F658. However, some knowledge of APC maximum concentration capability is necessary in order to avoid introduction of sizing errors as a result of excessive particle concentration during the sizing calibration procedure.1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For hazard statement, see Section 8.

定价： 0元

1.1 This practice covers procedures for estimating the dimensions and marking the boundaries of a soil absorption area for an on-site septic system involving residential-strength wastewater. It can also be used to estimate the dimensions of commercial on-site septic systems where wastewater strengths are similar to residential wastewater. 1.2 This practice can also be used for marking the boundaries of the area for a septic system construction filter bed. 1.3 This practice can be used at any site where a potentially suitable or recommended field area has been identified in accordance with Practices D 5879 and D 5921. 1.4 Non-metric units remain the common practice in design and installation of on-site waste disposal systems, and are used in this practice. Use of SI units given in parentheses is encouraged, if acceptable to the appropriate permitting agency. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

定价： 0元

定价： 1186元