微信公众号随时随地查标准

QQ交流1群(已满)

QQ群标准在线咨询2

QQ交流2群

购买标准后,可去我的标准下载或阅读

General Utility—The molecular mass (MM) and molecular mass distribution (MMD) are fundamental characteristics of a synthetic polymer that result from the polymerization process. The MM and MMD is useful for a wide variety of correlations for fundamental studies, processing and product applications. For example, it is possible to compare the observed MMD to predictions from an assumed kinetic or mechanistic model for the polymerization reaction. Differences between the values will allow alteration of the model or experimental design. Similarly, it is possible the strength, the melt flow rate, and other properties of a polymer are dependent on the MM and MMD. Determination of the MM and MMD are used for quality control of polymers and as specification in the commerce of polymers.Limitations—If the MMD is too wide, it is possible that the assumption of the constancy of the intensity scale calibration is in serious error.1.1 This test method covers the determination of molecular mass (MM) averages and the distribution of molecular masses for linear atactic polystyrene of narrow molecular mass distribution (MMD) ranging in molecular masses from 2000 g/mol to 35 000 g/mol by matrix assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF-MS). This test method is not absolute and requires the use of biopolymers for the calibration of the mass axis. The relative calibration of the intensity axis is assumed to be constant for a narrow MMD. Generally, this is viewed as correct if the measured polydispersity is less than 1.2 for the molecular mass range given above.1.2 The values stated in SI units are to be regarded as the standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.Note 1—There is no known ISO equivalent to this standard.

定价: 0

在线阅读 收 藏
DIN 18123 Determination of particle size distribution of soil 废止 发布日期 :  2001-11-01 实施日期 : 

定价: 442

在线阅读 收 藏
DIN 24147-2 Fittings for use in air distribution systems - Bends 废止 发布日期 :  2001-06-01 实施日期 : 

定价: 271

在线阅读 收 藏
DIN 24147-4 Fittings for use in air distribution systems - Tapers 废止 发布日期 :  2001-06-01 实施日期 : 

定价: 271

在线阅读 收 藏
DIN 24147-3 Fittings for use in air distribution systems - Gusseted bends 废止 发布日期 :  2001-06-01 实施日期 : 

定价: 271

在线阅读 收 藏

定价: 510

在线阅读 收 藏

定价: 271

在线阅读 收 藏
658 条记录,每页 15 条,当前第 28 / 44 页 第一页 | 上一页 | 下一页 | 最末页  |     转到第   页