定价：

定价：

定价：

定价： 345元 / 折扣价： 294 元

This PDF includes General Instruction #2. 1. Scope This section of IEC 598-2 specifies requirements for luminaires with built-in transformers for filament lamps, with supply voltages and output voltages not exceeding: - 1 000 V for class I and cla

定价： 819元 / 折扣价： 697 元

1.1 Scope This Standard applies to the safety of tungsten filament lamps intended for use in lighting equipment, designed to be installed on branch circuits not exceeding 750 V and used in accordance with the rules of the Canadian Electrical Code (CEC

定价： 1729元 / 折扣价： 1470 元

5.1 The procedures for the determination of properties of single-filament hose reinforcing wire made from steel are considered satisfactory for acceptance testing of commercial shipments of this product because the procedures are the best available and have been used extensively in the trade.5.1.1 In the case of a dispute arising from differences in reported test results when using these test methods for acceptance testing of commercial shipments, the purchaser and supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for investigation of bias. As a minimum, two parties should take a group of test specimens which are as homogeneous as possible and which are from a lot of material of the type in question. The test specimens then should be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared by using an appropriate statistical test and an acceptable probability level chosen by the two parties before testing is begun. If a bias is found, either its cause must be determined and corrected or the purchaser and supplier must agree to interpret future test results with consideration to the known bias.1.1 These test methods cover testing of single filament steel wires that are used to reinforce hose products. By agreement, these test methods may be applied to similar filaments used for reinforcing other rubber products.1.2 These test methods describe test procedures only and do not establish specifications or tolerances.1.3 These test methods cover the determinations of the mechanical properties listed below:  Property Section  Breaking force (strength)  7 – 13  Yield strength  7 – 13  Elongation  7 – 13  Knot strength 14 – 20  Torsion resistance 21 – 27  Reverse bend 28 – 34  Wrap 35 – 41  Diameter 42 – 481.4 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

定价： 0元

定价：

定价：

定价：

定价：

定价：

定价：

定价：

定价：