4.1 This test method can be used to distinguish between coolants that contribute to cavitation corrosion and erosion-corrosion of aluminum automotive water pumps and those that do not. It is not intended that a particular rating number, as determined from this test, will be equivalent to a certain number of miles in a vehicle test; however, limited correlation between bench and field service tests has been observed with single-phase coolants. Field tests under severe operating conditions should be conducted as the final test if the actual effect of the coolant on cavitation corrosion and erosion-corrosion is to be appraised. It is also possible, with proper control of the test variables, to determine the effect of pump design, materials of construction, and pump operating conditions on cavitation corrosion and erosion-corrosion damage.1.1 This test method covers the evaluation of the cavitation corrosion and erosion-corrosion characteristics of aluminum automotive water pumps with coolants.NOTE 1: During the development of this test method, it was found that results obtained when testing two-phase coolants did not correlate with results from field tests. Therefore, the test method cannot be recommended as being a significant test for determining cavitation effects of two-phase coolants.1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warning statements are given in 5.2.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 646元 加购物车

定价： 646元 加购物车

定价： 541元 / 折扣价： 482 元 加购物车

定价： 260元 / 折扣价： 221 元 加购物车

定价： 0元 / 折扣价： 0 元 加购物车

定价： 0元 加购物车

定价： 1464元

定价： 229元

Update #2 was published as notification that this is now a National Standard of Canada. This PDF includes Update #2. 1. Scope 1.1 This Standard applies to motor-operated liquid pump units, for use in nonhazardous, indoor, outdoor (exposed), and

定价： 728元 / 折扣价： 619 元

定价： 731元

定价： 683元 / 折扣价： 581 元

定价： 598元

定价： 229元

定价： 462元

定价： 462元