定价： 无文本 / 折扣价： 0 元

定价： 无文本 / 折扣价： 0 元

定价： 无文本 / 折扣价： 0 元

5.1基本条件服务机构应满足以下条件：a)应遵循WS/T367等标准要求和相关法律法规规定；b)主要负责人须经过生产安全培训，并持有安全生产监督管理部门颁发的安全员证；c)消毒产品须使用具有卫生许可证、产品备案的检验报告等证件齐全的合格产品；d)有完善的安全、质量、技术、施工、文明作业等操作规程,有健全的财务、人事等方面管理制度；e)具有能满足不同环境和特殊场所要求的设备；f)近2年内无不良经营记录。

定价： 无文本 / 折扣价： 0 元

本文件规定了室内环境污染净化治理服务管理（以下简称“净化治理服务”）的术语和定义，基本要求，服务要求，仪器、设备与净化产品，施工要求，净化治理验收及跟踪服务。本文件适用于民用建筑场所（公共建筑和居住建筑）的室内环境污染的治理服务；其它室内环境可参照执行。

定价： 0元 / 折扣价： 0 元

定价： 无文本 / 折扣价： 0 元

定价： 无文本 / 折扣价： 0 元

定价： 无文本 / 折扣价： 0 元

5.1洁净室设计施工机构评级基本条件洁净室设计施工能力等级评定遵循自愿和确有需求的原则，同时满足以下要求：a）具有法人资格和固定的能满足需要的办公场所；b）具有满足本文件要求的资产；c）从事洁净室设计施工的企业及其他单位；d）具有满足本文件要求的专业设计及施工管理人员；e）具有必要的技术装备；f）具有满足本文件要求的相关业绩。5.2有关说明有关说明如下：a）专业设计及施工管理人员是指必须持有相关政府部门、高等院校、省级以上社团组织颁发的与洁净室设计、施工管理等相关能力培训证书的人员；b）本文件要求的业绩是指独立完成的洁净室专业的设计或施工的案例；c）本文件的“以上”、“以下”、“不少于”、“超过”和“不超过”均含本数。

定价： 无文本 / 折扣价： 0 元

定价： 590元 加购物车

5.1 This test method differentiates the relative corrosion-preventive capabilities of lubricating greases under the test conditions.1.1 This test method covers the determination of the corrosion-preventive properties of greases using grease-lubricated tapered roller bearings exposed to various concentrations of dilute synthetic sea water stored under wet conditions. It is based on Test Method D1743, which is practiced using a similar procedure and distilled water. The reported result is a pass or fail rating as determined by at least two of three bearings.1.2 Apparatus Dimensions—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.3 All Other Values—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 590元 加购物车

5.1 DOSS is an anionic detergent that is approved by the United States Food and Drug Administration (U.S. FDA) and is used widely as a laxative, emulsifying, solubilizing, and dispersing agent, and is used in the cosmetic industry.4 DOSS may also be used as a dispersing agent to treat oil. DOSS may be released into the environment at levels that may be harmful to aquatic life. The U.S. EPA aquatic life benchmark for DOSS is 40 ppb.55.2 This test method has been investigated for use with reagent and sea water.1.1 This test method covers the determination of dioctyl sulfosuccinate (DOSS) in sea water by direct injection using liquid chromatography (LC) and detection with tandem mass spectrometry (MS/MS). This analyte is qualitatively and quantitatively determined by this test method. This test method adheres to selected reaction monitoring (SRM) mass spectrometry.1.2 The detection verification level (DVL) and reporting range for DOSS are listed in Table 1.1.2.1 The DVL is required to be at a concentration at least 3 times below the reporting limit (RL) and have a signal/noise ratio greater than 3:1. Fig. 1 and Fig. 2 display the signal/noise ratio of the selected reaction monitoring (SRM) transition.FIG. 1 Detection Verification Level Signal/Noise RatioFIG. 2 Reporting Level Signal/Noise Ratio1.2.2 The reporting limit is the concentration of the Level 1 calibration standard as shown in Table 5 for DOSS, taking into account the 50 % sample preparation dilution factor.1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 646元 加购物车

定价： 646元 加购物车

5.1 The use of plastics aboard ships is on the rise and the use of the sea as a trash dumping site is no longer a possibility; consequently, the disposal of plastic materials while at sea remains a major issue. It is possible that biodegradable plastics will help to allay public concern by allowing for the safe disposal of plastic materials at sea. This test method has been developed to assess the rate and degree of aerobic biodegradation of plastics exposed to marine microorganisms. Aerobic biodegradation is determined by measuring the amount of biogas (carbon dioxide) produced during such an exposure.5.2 It is acceptable to use the degree and rate of aerobic biodegradability of a plastic under the conditions of this test method to estimate the persistence of that plastic in biologically active marine environments, for example, seashore and open-ocean. However, it shall be recognized that predicting long-term environmental fate and effects from the results of short-term exposure to a simulated marine environment is difficult. Thus, caution shall be exercised when extrapolating the results obtained from this or any other controlled-environment test to disposal in the natural environment.1.1 This test method is used to determine the degree and rate of aerobic biodegradation of plastic materials (including formulation additives) exposed to pre-grown population of at least ten aerobic marine microorganisms of known genera or the indigenous population existing in natural seawater. The test method is conducted under controlled laboratory conditions.1.2 This test method is designed to index polymer materials that are possibly biodegradable, relative to a positive reference material, in an aerobic environment.1.3 This test method is applicable to all polymer materials containing at least 20 % carbon that are not inhibitory to the microorganisms present in a marine environment.1.4 The values stated in SI units are to be regarded as the standard.1.5 There is no known ISO equivalent to this standard.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 590元 加购物车

定价： 590元 加购物车