
【国外标准】 IEEE Guide for Fault Current Limiter (FCL) Testing of FCLs Rated above 1000 V AC
本网站 发布时间:
2025-04-28
- IEEE C37.302-2015
- 定价: 82元 / 折扣价: 70 元
- 在线阅读
开通会员免费在线看70000余条国内标准,赠送文本下载次数,单本最低仅合13.3元!还可享标准出版进度查询、定制跟踪推送、标准查新等超多特权!  
查看详情>>

适用范围:
This guide describes the testing of fault current limiters (FCLs) operating on condition-based impedance increase for AC systems 1000 V and above. This guide does not include constant impedance series reactors and single fuses. (For standards specific to these fault current limiting devices, see IEEE Std C57.16(TM)1,2,3 and IEEE Std C37.46(TM)). NOTE--Testing of FCL load current interrupting capabilities are not addressed in this guide and may be discussed between user and manufacturer.
标准号:
IEEE C37.302-2015
标准名称:
IEEE Guide for Fault Current Limiter (FCL) Testing of FCLs Rated above 1000 V AC
英文名称:
标准状态:
-
发布日期:
-
实施日期:
出版语种:
- 推荐标准
- ASTM E259-06(2015) Standard Practice for Preparation of Pressed Powder White Reflectance Factor Transfer Standards for Hemispherical and Bi-Directional Geometries
- ASTM E2752-10(2015) Standard Guide for Evaluation of Residual Effectiveness of Antibacterial Personal Cleansing Products
- ASTM E2784-10(2015) Standard Test Method for Evaluation of the Effectiveness of Handwash Formulations Using the Paper Towel (Palmar) Method of Hand Contamination
- ASTM F1035-03(2015) Standard Practice for Use of Rubber-Cord Pie Disk to Demonstrate the Discernment Capability of a Tire X-ray Imaging System
- ASTM F2255-05(2015) Standard Test Method for Strength Properties of Tissue Adhesives in Lap-Shear by Tension Loading
- ASTM F2258-05(2015) Standard Test Method for Strength Properties of Tissue Adhesives in Tension
- ASTM F2392-04(2015) Standard Test Method for Burst Strength of Surgical Sealants
- ASTM F2819-10(2015)e2 Standard Test Methods for Measurement of Straightness of Bar, Rod, Tubing and Wire to be used for Medical Devices
- ASTM F665-09(2015) Standard Classification for Vinyl Chloride Plastics Used in Biomedical Application
- ASTM F754-08(2015) Standard Specification for Implantable Polytetrafluoroethylene (PTFE) Sheet, Tube, and Rod Shapes Fabricated from Granular Molding Powders
- ASTM C1000-19 Standard Test Method for Radiochemical Determination of Uranium Isotopes in Soil by Alpha Spectrometry
- ASTM C1006/C1006M-20a Standard Test Method for Splitting Tensile Strength of Masonry Units
- ASTM C1007-20 Standard Specification for Installation of Load Bearing (Transverse and Axial) Steel Studs and Related Accessories
- ASTM C1012/C1012M-18b Standard Test Method for Length Change of Hydraulic-Cement Mortars Exposed to a Sulfate Solution
- ASTM C1016-14(2022) Standard Test Method for Determination of Water Absorption of Sealant Backing (Joint Filler) Material