【国外标准】 Standard Test Methods for Solvent Bearing Bituminous Compounds

3.1 These tests are useful in sampling and testing solvent bearing bituminous compounds to establish uniformity of shipments.1.1 These test methods cover procedures for sampling and testing solvent bearing bituminous compounds for use in roofing and waterproofing.1.2 The test methods appear in the following order:  SectionSampling 4Uniformity 5Weight per gallon 6Nonvolatile content 7Solubility 8Ash content 9Water content 10Consistency 11Behavior at 60°C [140°F] 12Pliability at –0°C [32°F] 13Aluminum content 14Reflectance of aluminum roof coatings 15Strength of laps of rolled roofing adhered with roof adhesive 16Adhesion to damp, wet, or underwater surfaces 17Mineral stabilizers and bitumen 18Mineral matter 19Volatile organic content 201.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.