【国外标准】 Standard Test Methods for Carbon Black—Dispersion in Rubber

5.1 Visual dispersion ratings correlate with certain important physical properties of the compound. A rating of 5 indicates a state of dispersion developing near maximum properties, while a rating of 1 would indicate a state of dispersion developing considerably depressed properties. Normally, the visual dispersion ratings indicate the following levels of compound quality:Visual Dispersion Rating Classification   4 to 5 High3 to 4 Intermediate2 to 3 Low1 to 2 Very low1.1 These test methods cover the degree of dispersion of carbon black in rubber. Four test methods are described as follows:  Sections  Test Method A—Visual Inspection  3 – 11  Test Method B—Agglomerate Count 12 – 22  Test Method C—Microroughness Measurement      with Profilometer 23 – 33  Test Method D—Microroughness Measurement with IFM 34 – 421.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.