【国外标准】 Standard Practice for Reporting Results of Examination and Analysis of Deposits Formed from Water for Subsurface Injection

5.1 This practice sets down the manner in which data obtained from other test methods should be reported. This is done in an effort to standardize the report form used.1.1 This practice covers the manner in which the various results of examination and analysis to determine the composition of deposits formed from water for subsurface injection are to be reported.1.2 All analyses shall be made in accordance with the test methods of ASTM, unless otherwise specified.NOTE 1: While reporting of inorganic constituents in water-formed deposits as specified in Practice D933 is sufficient for certain industries, this practice provides for the reporting of organic and biological materials as well as inorganic constituents.NOTE 2: Consistent with practices in industries where subsurface injection of water is practiced, reporting includes specifying of inorganic constituents as probable molecular combinations of the species for which analyses are performed.1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.