【国外标准】 Standard Specification for Fly Ash Facing Brick

This specification covers fly ash brick intended for use in masonry, which are made from fly ash, water, and suitable mineral aggregates with or without the inclusion of other materials, and without the use of portland cement. Units that fall under this specification include a fly ash binder that undergoes hydraulic, pozzolanic, alkali-activated, or geopolymer reactions, or any combination thereof. These chemical reactions, in conjunction with the other materials in the units, provide the strength and durability necessary to meet the requirements of this specification. The specification includes cementitious materials, aggregates, and pigments for integrally colored concrete; physical requirements, strength, durability, and shrinkage; permissible variation in dimensions; finish and appearance; sampling and testing; and compliance. A table presents the strength, absorption, and density classification requirements addressed by this specification.1.1 This specification covers fly ash brick intended for use in masonry, which are made from fly ash, water, and suitable mineral aggregates with or without the inclusion of other materials, and without the use of portland cement. This specification covers units intended for use in masonry, in both structural and facing applications.1.2 Units covered under this specification include a fly ash binder that undergoes hydraulic, pozzolanic, alkali-activated, or geopolymer reactions, or any combination thereof. These chemical reactions, in conjunction with the other materials in the units, provide the strength and durability necessary to meet the requirements of this specification.NOTE 1: This specification addresses properties of units formed using fly ash, aggregates, and other allowed binders. Although not required by this standard, users may request tests that establish assembly performance such as unit-mortar bond and fire resistance.1.3 This specification references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.