【国外标准】 Standard Guide for Qualification and Control of Induction Heat Treating

4.1 This guide helps purchasers assess induction processes including the critical parameters that can affect product quality. It guides the evaluation of heat-treating vendor performance and capabilities to ensure higher and more consistent product quality.4.2 Refer to Appendix X1 for a flow chart for the use of this guide.1.1 This guide covers the process control and product properties verification of continuous heat treating of material using a quench and temper induction process (surface hardening, surface heat treating, and batch heat-treated products using induction are not considered in this guide). Examples of products covered by this guide may include products covered by API Specifications 20E, 5L, and 5CT.1.2 This guide indicates some features of induction heat treating compared to furnace heat treating. Induction heat treating processes typically operate at higher temperatures compared to furnace processes.1.3 This guide addresses the features and requirements necessary for induction heating and ancillary equipment. However, induction equipment may be used in combination with convection heating equipment (for example, gas or electric furnaces).1.4 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.