【国外标准】 Standard Test Methods for Coated Fabrics

3.1 Coated fabrics and rubber products made from coated fabrics are important items of commerce, and adequate test methods must be available to ensure the quality of these products. These test methods provide for this testing capability.1.1 These test methods cover, but are not limited to, rubber-coated fabrics, that is, tarpaulins, rainwear, and similar products.1.2 The scope of each of these test methods appears in the section in which the test method is described.1.3 The test methods appear in the following sections:Test Method SectionDimensions and Mass 7 – 10Breaking Strength 11 Procedure A—Grab Test Method 12 – 15 Procedure B—Cut Strip Test Method 16Elongation 17Bursting Strength 18 Procedure A – Ball Burst Method 19 – 22 Procedure B – Diaphragm Burst Method 23 – 26Puncture Resistance 27 – 30Tearing Strength 31 Procedure A—Pendulum Method 32 Procedure B—Tongue Tear Method 33 – 36Trapezoidal Tear 37 – 40Hydrostatic Resistance 41 Procedure A—Mullen Type Tester 42 – 45 Procedure B—Rising Water Column Tester 46 – 49Adhesion Coating (to Fabrics) 50 – 53Strength of Coating 54 – 58Tack-Tear Resistance 59 – 63Low Temperature Bend Test 64Low Temperature Impact Test 65Low-Temperature Crack Resistance 66 – 70Seam Strength 71 – 76Accelerated Heat Aging (Oven Method) 77 – 84Dead Load Seam Strength 85 – 88Blocking Resistance at Elevated Temperatures 89 – 93Crush Resistance 94 – 98Wicking of Coated Cloth 99 – 1021.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.