1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial deep fat fryers including pressurixed types not intended for household use, their rated voltage being not more than 250 V for sing

定价： 455元 / 折扣价： 387 元

1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial grillers and toasters not intended for household use, their rated voltage being not more than 250 V for single-phase appliances co

定价： 364元 / 折扣价： 310 元

4.1 Upon mutual agreement between the purchaser and the supplier, woven and knitted products intended for this end use should meet all of the requirements listed in Table 1 of this specification.4.2 It is recognized that for purposes of fashion or aesthetics, the ultimate consumer of articles made from these fabrics may find acceptable products that do not conform to all of the requirements in Table 1. Therefore, one or more of the requirements listed in Table 1 may be modified by mutual agreement between the purchaser and the supplier.4.2.1 In such cases, any references to the specification shall specify that: “This product meets ASTM Specification ____ except for the following characteristic(s).”4.3 Where no prepurchase agreement has been reached between the purchaser and the supplier, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 4.2, ultimate consumer demands dictate varying performance parameters for any particular product.4.4 The uses and significance of particular properties and test methods are discussed in the appropriate sections of the specified test methods. For additional information see Test Methods D629, Practice D1776, and Guide D3938.1.1 This specification covers the evaluation of specific performance characteristics of importance in woven and knit flat, fitted, and waterbed sheet products for use in institutional and household environments.1.2 This specification may be used by mutual agreement between the purchaser and the supplier to establish purchasing specification requirements.1.3 The requirements in Table 1 apply to the length and width directions for those properties where fabric direction is pertinent.1.4 This specification is not applicable to woven and knit products used for sheet blankets or to woven and knitted sheet products used for apparel.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车

1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated commercial hot cupboards, not intended for household use, their rated voltage being not more than 250 V for single-phase appliances connected

定价： 410元 / 折扣价： 349 元

CSA Preface This is the second edition of CAN/CSA-E60335-2-5, Household and similar electrical appliances - Safety - Part 2-5: Particular requirements for dishwashers, which is an adoption, with Canadian deviations, of the identically titled CEI/IEC (C

定价： 819元 / 折扣价： 697 元

4.1 Upon mutual agreement between the purchaser and the supplier, woven products intended for this end use should meet all of the requirements listed in Table 1 of this specification.4.2 It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable products that do not conform to all of the requirements in Table 1. Therefore, one or more of the requirements listed in Table 1 may be modified by mutual agreement between the purchaser and the supplier.4.2.1 In such cases, any references to the specification shall specify that: This product meets Specification D5432 except for the following characteristic(s).4.3 Where no prepurchase agreement has been reached between the purchaser and the supplier, and in case of controversy, the requirements listed in Table 1 are intended to be used as a guide only. As noted in 4.2, ultimate consumer demands dictate varying performance parameters for any particular style.4.4 The significance and use of particular properties and test methods are discussed in the appropriate sections of the specified test methods.1.1 This specification covers the evaluation of specific performance characteristics of importance in thermal woven, conventional woven, flocked, nonwoven, and knitted blanket products for use in institutional and household environments.1.2 This specification may be used by mutual agreement between the purchaser and the supplier to establish purchasing specification requirements.1.3 The requirements in Table 1 apply to the length and width directions for those properties where fabric direction is pertinent.1.4 This specification does not include requirements for electric blankets. Electric blankets are specified under UL 964 requirements dictated by the Underwriter's Laboratories.1.5 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

定价： 515元 / 折扣价： 438 元 加购物车

1. Scope This clause of part 1 is replaced by: This standard deals with the safety of electrically operated bains-marie not intended for household use, their rated voltage being not more than 250 V for single-phase appliances connected between one p

定价： 410元 / 折扣价： 349 元

5.1 Upon mutual agreement between the purchaser and the supplier, woven or knitted products intended for this end use should meet all of the requirements listed in Table 1 of this specification for terry products and Table 2 for non terry products.5.2 It is recognized that for purposes of fashion or aesthetics the ultimate consumer of articles made from these fabrics may find acceptable products that do not conform to all of the requirements in Table 1 or Table 2. Therefore, one or more of the requirements listed in Table 1 or Table 2 may be modified by mutual agreement between the purchaser and the seller.5.2.1 In such cases, any references to the specification shall specify that: This product meets ASTM Specification 63-707 except for the following characteristic(s).5.3 Where no prepurchase agreement has been reached between the purchaser and the supplier, and in case of controversy, the requirements listed in Table 1 or Table 2 are intended to be used as a guide only. As noted in 5.2, ultimate consumer demands dictate varying performance parameters for any particular style.5.4 The significance and use of particular properties and test methods are discussed in the appropriate sections of the specified test methods.1.1 This specification covers the evaluation of specific performance characteristics of importance in woven and knitted kitchen towel, dishcloth, crash towel, huck towel, washcloth, hand towel, bath towel, and bath sheet products for use in institutional and household environments.1.2 This specification may be used by mutual agreement between the purchaser and the supplier to establish purchasing specification requirements.1.3 The requirements in Tables 1 and 2 apply to the length and width directions for those properties where fabric direction is pertinent.1.4 This specification is not applicable for coated and laminated products, nonwoven products, or terry fabrics used for apparel.1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车

1 Scope This clause of part 1 is replaced by: This standard deals with the safety of stationary electric circulation pumps intended for use in heating systems or in service water systems, having a rated power input not exceeding 300 W, their rated vo

定价： 410元 / 折扣价： 349 元

1 Scope This clause of part 1 is replaced by: This standard deals with the safety of electric oral hygiene appliances for household and similar purposes, their rated voltage being not more than 250 V. NOTE 1 - Examples of appliances covered by thi

定价： 410元 / 折扣价： 349 元

1 Scope This clause of part 1 is replaced by: This standard deals with the safety of electric cleaning appliances for household use which are intended for cleaning surfaces such as windows, walls and empty swimming pools by using liquid cleansing a

定价： 637元 / 折扣价： 542 元

This PDF includes GI #2 to #4. 1. Scope 1.1 This Standard applies to cord-connected and permanently connected cooking and liquid-heating appliances rated for use on nominal single-phase system voltages of 240 V and less, designed to be used in non

定价： 683元 / 折扣价： 581 元

This specification covers the requirements for gloves made of rubber-like latex, whether made of natural or synthetic materials, unsupported with or without a flock lining, intended for household, beautician, or general use. This specification serves as a guide to permit obtaining gloves of consistent performance, and does not address the safe and proper use of gloves. Sampled specimens shall be tested and conform accordingly to dimensions (width, length, and finger and palm thickness) in accordance to size, and physical requirements (tensile strength and ultimate elongation) before and after accelerated aging. Gloves shall have surfaces that may be smooth or textured, with or without a pattern on the finger surface, and may have a rolled, natural edge or cut cuff. In any case, the gloves shall either be ambidextrous, or in pairs (right and left hand) and matched in design.1.1 This specification covers requirements for gloves made of rubber-like latex, whether made of natural or synthetic materials, unsupported with or without a flock lining, intended for household, beautician use, or general use.1.2 This specification is intended to serve as a guide to permit obtaining gloves of consistent performance. The safe and proper use of gloves is excluded from the scope of this specification.1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车

This PDF includes GI #2. 1. Scope 1.1 This Standard applies to motor-operated appliances intended for use on nominal system voltages of 600 V and less, except that where appliances are driven by universal-type motors or electromagnetic mechanisms

定价： 819元 / 折扣价： 697 元

This guide is written for all persons involved with HHWCs, but especially for those primarily responsible for establishing and providing training to workers at HHWCs. This guide is intended to provide recommended training topics which should be covered during the initial baseline and annual refresher training. The actual topics and depth of training for each worker must be assessed by the HHWC operator on a case-by-case basis with emphasis on the particular job assignment for each worker. The major factors the operator should consider are what are the anticipated hazards to which each worker may be exposed and what are the controls/work practices which the worker must know in order to do his or her job assignments safely.Another factor which the operator must consider is the areas in which each worker is expected to work or the areas to which each worker has access to as part of job assignments. For example, if an administrative assistant only has access to the office area, and never enters the active HHWC area, then training may be limited to required actions as part of the contingency plan. If, however, the administrative assistant is periodically required to enter into the active HHWC area, more detailed training is required based on anticipated hazards which the administrative assistant may be exposed to while in the HHWC area.When deciding on the training topics for the annual refresher training, the HHWC operator must decide on topics in Section 7 which are relevant to the HHWC workers attending the refresher training class. Factors which should be considered are:4.3.1 Hazards to which the workers may be exposed to,4.3.2 Changes in the standard operating procedures, contingency plan since the previous training,4.3.3 Length of time from which a worker has received training in the topics listed in Section 7, and4.3.4 Identification of incidents, hazards, unsafe conditions, or any other situations which indicate a need to retrain workers in a particular topic to ensure a safe and healthful workplace.1.1 This guide covers recommended health and safety training topics for workers at operations for the collection of household hazardous waste or conditionally exempt small quantity generator waste, or both, regardless of the type of collection. Although this guide is intended to protect the worker, public health, and the environment, it is not intended to satisfy all the health and safety training requirements under the Occupational Safety and Health Act of 1970 or the Resource Conservation and Recovery Act of 1976. Additionally, local and state requirements may also vary. Therefore, it is recommended that the operator of a household hazardous waste collection operation also check federal, state, and local regulations for additional requirements.This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this guide to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

定价： 0元 / 折扣价： 0 元