定价： 481元 / 折扣价： 409 元 加购物车

定价： 345元 / 折扣价： 294 元 加购物车

5.1 Maps, automobile odometers, and highway and distance markers are not sufficiently accurate to describe the length of a route for tire testing purposes. The proposed procedure describes a test method for measuring the length of a road course with sufficient accuracy for tire testing purposes.1.1 This test method covers the determination of the accurate length measurement of road courses used for testing all types of pneumatic tires on various associated vehicles.1.2 This test method is intended for use on public highways or closed circuit test courses, or both, that cannot be measured practically by surveying techniques.1.3 Use of this test method requires that the surface of the test course to be measured shall be sufficiently smooth to preclude bounce or hop of the fifth wheel, which will affect the accuracy of the measurement. The normal highway surface is adequate for this test method.1.4 It is not the intent or scope of this test method to encompass distance measurements of test courses whose surfaces are irregular, broken up, jagged, and so forth, such as rock courses, Belgian block, “rumble” surfaces, and the like. Snow- and ice-covered surfaces also are excluded.1.5 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.1.7 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车

5.1 This test method may be used for calibration of speed and distance measurement systems used on tire test vehicles and tire test trailers, or any land-based vehicle that contacts the road and that uses a trailing-wheel system for measurement of speed and distance. This test method applies only to hard, dry, smooth surfaces and is not accurate for highly curved vehicle paths. This test method does not encompass optical types of devices.1.1 This test method covers the determination of vehicle speed and cumulative distance traveled using a device termed a fifth wheel and using appropriate associated instrumentation.1.2 This test method also describes the calibration technique applicable to digital or analog speed and distance measurement systems employing a fifth wheel.1.3 The values stated in SI (millimetre-kilogram) units are to be regarded as the standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

定价： 515元 / 折扣价： 438 元 加购物车