【国外标准】 Standard Test Methods of Conducting Strength Tests of Panels for Building Construction

8.1 The procedures described are those that will test the behavior of segments of wall construction under conditions representative of those encountered in service. Performance criteria based on data from those procedures can ensure structural adequacy and service life.1.1 These test methods cover the following procedures for determining the structural properties of segments of wall, floor, and roof constructions:  SectionTest Specimens  3Loading  4Deformation Measurements  5Reports  6Precision and Accuracy  7TESTING WALLS  8Compressive Load  9Tensile Load 10Transverse Load—Specimen Horizontal 11Transverse Load—Specimen Vertical 12Concentrated Load 13Impact Load—See Test Methods E695 and E661  Racking Load—Evaluation of Sheathing Materials on a Standard Wood Frame 14Racking Load—Evaluation of Sheathing Materials (Wet) on a Standard Wood Frame 15TESTING FLOORS 16Transverse Load 17Concentrated Load 18Impact Load—See Test Methods E695 and E661  TESTING ROOFS  Section 19Transverse Load 20Concentrated Load 21APPENDIXTechnical Interpretation Appendix X11.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.