【国外标准】 Standard Practice for Application of Heat Weldable Atactic Polypropylene (APP) Modified Bituminous Waterproofing Membranes Systems for New Building Decks (Withdrawn 2015)

本网站发布时间： 2024-02-28

ASTM D6950/D6950M-04(2012)e1
Withdrawn, No replacement
定价： 0元
在线阅读

开通会员免费在线看70000余条国内标准，赠送文本下载次数，单本最低仅合13.3元！还可享标准出版进度查询、定制跟踪推送、标准查新等超多特权！查看详情>>

标准简介

适用范围：

4.1 This practice provides general procedures, information, guidelines, and precautions for the application of heat welded modified bituminous waterproofing systems used as part of a new horizontal waterproofing system.4.2 This practice is not all-inclusive and is intended only to supplement detailed instructions from designers and system manufacturers.4.3 The horizontal (low sloped) deck or substrate referred to in this practice is reinforced cast-in-place structural concrete.1.1 This practice covers the minimum application recommendations for heat weldable atactic polypropylene (APP) modified bituminous systems used as part of a new horizontal waterproofing system over occupied spaces of buildings where covered by a separate wearing course.1.2 For the purpose of this practice, the substrate shall be structurally sound, sloped to drain, able to accept the weight of the membrane and other system materials, and meet the local building code requirements. Similarly, all components of the waterproofing system are assumed to comply with any federal, state, and local environmental regulations that may be in effect at the time of installation. Expansion joints, insulation, drainage layers, protection boards, filter sheets, and the wearing surfaces are beyond the scope of this practice.1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

基本信息

标准号：
ASTM D6950/D6950M-04(2012)e1
标准名称：
Standard Practice for Application of Heat Weldable Atactic Polypropylene (APP) Modified Bituminous Waterproofing Membranes Systems for New Building Decks (Withdrawn 2015)
英文名称：
Standard Practice for Application of Heat Weldable Atactic Polypropylene (APP) Modified Bituminous Waterproofing Membranes Systems for New Building Decks (Withdrawn 2015)
标准状态：
Withdrawn, No replacement
发布日期：
实施日期：
出版语种：

标准分类号

标准ICS号：
中标分类号：

关联标准

替代以下标准：
被以下标准替代：
引用标准：
采用标准：

出版信息

页数：
0 页
字数：
开本：

其他信息

起草人：
起草单位：
归口单位：
提出部门：
发布部门：

其它标准

推荐标准